The LED labelled Link will blink during initialisation then after a couple of minutes will remain a steady green. If the link LED keeps blinking your modem is unable to establish a broadband connection. Open your internet browser e. Internet Explorer, Firefox, or Safari and type On the page that appears, click on Internet Connection in the blue menu of options on the left side of the page. The modem will now connect to the Internet - this may take a few minutes.
You can check if the connection has been set up by pressing the Refresh button on the right upper side of the page. The light labelled Internet on the right side of the page will turn to green if the connection has been set up.
Close and reopen your browser. The self-installation CD contains simple step by step instructions for installing your modem. It also installs and configures all the software you will need to connect to your Optus DSL Broadband service. Speaking personally as a technician -- manual wan DNS settings. This is the procedure NCF uses to broadband access - sagemcom magyarorsz g kft. Post Options. Versions: 4. Wireless Networks and WEP. Tiny Software Personal Firewall v1.
Linksys Instant GigaDrive. Why encrypt your online traffic with VPN? Satellite Internet - What is it? Broadband Forums General Discussion Gallery. Console Gaming. F st Features. Hardware revision:. WAN ports:. WAN port s type:.
LAN ports:. LAN ports type:. LAN ports auto cross-over:. I found this out the hard way by using a folder called "Modem Driver" and the build problems took me a while to figure out Once in there you can build the driver with the command: sudo make You will need to enter your regular user password to confirm your identity for running a system task.
Don't worry, your typing is being recognised, it just isn't shown in case someone is looking over your shoulder Hopefully that didn't give an error if it did then try the forums or the driver's wiki , so now you can install it with: sudo make install Since you typed your password a few minutes ago it won't bother asking this time If that went well then the driver is installed, but we need to give it the firmware. If not then check the note above to make sure the older eagle-usb driver is not being used Configuring The Connection Now the modem is working we just need to tell it how to connect to our ISP.
There is a nice list here for some countries. Save this file and close it. If the page appears then it worked. To turn off the connection type in the console: poff or poff ueagle-atm Automating The Connection Starting At Boot If your connection works then you can launch it automatically at startup using the regular boot scripts system.
If so then please add any shutdown commands you use. If the script is run with any options other than start or stop then it will print a usage message and fail. Save that file and close the text editor. This is done with the command: sudo update-rc. For your menu entry you should set the command: box to say reconnect-script , then set the other parameters to whatever you like.
0コメント